Samsung NE63T8111SS/AA User Manual - Page 39

Maintaining your appliance Before a self-cleaning cycle • • • Fig. 1 • Don't hand clean the oven door • gasket. Fig. 2 You may hand clean the door. • • We recommend venting your kitchen with an open window or using a ventilation fan or hood during the selfcleaning cycle. Remove the wire rack, broil pan, broil pan insert, all cookware, and any aluminum foil from the oven. Wipe up debris from the oven bottom. (Fig. 1) The silver-colored oven racks can be self-cleaned, but they will darken, lose their luster, and become hard to slide. Residue on the front frame of the range and outside the gasket on the door will need to be cleaned by hand. Clean these areas with hot water, soap-filled steel-wool pads, or cleansers, such as Soft Scrub. Rinse well with clean water and dry. Do not clean the gasket. The fiberglass material of the oven door gasket cannot withstand abrasion. It is essential for the gasket to remain intact. If you notice it becoming worn or frayed, have it replaced. (Fig. 2) Make sure the oven light bulb cover is in place and the oven light is off. NOTE Remove oven racks and accessories before starting the self-clean mode. How to run a self-cleaning cycle 1. Select the length of time for the self-cleaning operation, e.g., 3 hours. Press Self Clean once for a 3 hour clean time, twice for a 5 hour clean time, or 3 times for a 2 hour clean time The default setting is 3 hours. 2. Press START/SET to start the self-cleaning cycle. The motor-driven door lock will engage automatically. NOTE • You will not be able to start a self-cleaning cycle if the control lock feature is activated or if the oven's temperature is too hot. • The oven door locks automatically. The display will show the cleaning time remaining. It is not be possible to open the oven door until the temperature drops to a safe and cool temperature. • The self-cleaning feature will not operate when the warming center is on. 3. When the self-cleaning cycle is done, End will appear in the display and the range will beep several times. How to delay the start of self-cleaning 1. Press Self Clean. Select the desired self-clean time by pressing Self Clean. 2. Press Delay Start. 3. Enter the time you want the clean cycle to start. 4. Press START/SET. The display will show Delay, Self clean, and the Lock icon. The motor-driven door lock will engage automatically. 5. The Self-Cleaning cycle will turn on automatically at the set time. NE63T811_AA_DG68-01212A-00_EN.indd 39 English 39 2020-03-24 7:09:52