Samsung NE63T8111SS/AA User Manual - Page 45

Maintaining your appliance Potential for permanent damage to the glass surface • Sugary spillovers (such as jellies, fudge, candy, syrups) or melted plastics can cause pitting of the surface of your cooktop. This is not covered under the warranty. You should clean the spill while it is still hot. Take special care when removing hot substances. Refer to the section below. • When using a scraper, be sure it is new and the razor blade is still sharp. Do not use a dull or nicked blade. Cleaning sugary spills and melted plastic 1. Turn off all surface units. Remove hot pans. 2. Wearing an oven mitt, use a single-edge razor blade scraper to move the spill to a cool area of the cooktop. Remove the spill with paper towels. 3. Any remaining spillover should be left until the surface of the cooktop has cooled. 4. Don't use the surface units again until all of the residue has been completely removed. NOTE If pitting or indentations in the glass surface have already occurred, the cooktop glass will have to be replaced. In this case, service will be necessary. Removing and reinstalling the oven door How to remove the door CAUTION • The door is very heavy. Be careful when removing and lifting the door. Do not lift the door by the handle. • Turn the power OFF before removing the door. Hinge lock Locked position Unlocked position 1. Open the door completely. 2. Pull the hinge locks down toward the door frame to the unlocked position. about 5 ° 3. Firmly grasp both sides of the door at the top. 4. Close the door to the door removal position, which is approximately 5 degrees from vertical (Fig. 1). Fig. 1 NE63T811_AA_DG68-01212A-00_EN.indd 45 English 45 2020-03-24 7:09:53