Samsung NP-N310 User Guide - Page 92
General, Connect using, Internet ProtocolTCP/IP, Properties, Obtain an IP address, automatically
UPC - 036725722392
View all Samsung NP-N310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
4 Click General tab and select a LAN driver from Connect using:. Select Internet Protocol(TCP/IP) and click Properties. The displayed LAN driver may vary depending on the LAN device type. Click Install to add a network component as shown in the figure below: You can add a client, a service, or a protocol. 5 Configure IP settings. Select Obtain an IP address automatically when using DHCP. If you use a static IP, select Use the following IP address and enter the values. If the IP of your computer is not automatically assigned, contact the network administrator. 6 If all settings are made, click OK. Now the network configuration is finished. 91
¶1
4
Click
General
tab and select a LAN
driver from
Connect using:
. Select
Internet Protocol(TCP/IP)
and click
Properties
.
The displayed LAN driver may vary
depending on the LAN device type.
Click
Install
to add a network
component as shown in the figure
below: You can add a client, a
service, or a protocol.
5
Configure IP settings.
Select
Obtain an IP address
automatically
when using DHCP. If
you use a static IP, select
Use the
following IP address
and enter the
values.
If the IP of your computer is not
automatically assigned, contact the
network administrator.
6
If all settings are made, click
OK
. Now
the network configuration is finished.