Samsung RF23HSESBSR User Manual Ver.03 (English, French, Spanish) - Page 17

setting up INSTALLING THE WATER DISPENSER LINE A water dispenser with a filter is one of the helpful features on your new refrigerator. To help promote better health, the water filter removes unwanted particles from your water. However, it does not sterilize the water or destroy microorganisms. You may need to purchase a water purifying system to do that. The water line also connects to the ice maker. For the ice maker to operate properly, water pressure of 20 ~ 125 psi (138 ~ 862 kPa) is required. If the refrigerator is installed in an area with low water pressure (below 20 psi), you can install a booster pump to compensate for the low pressure. After you have connected the water line, make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet. Water line installation kits are available at extra cost from your dealer. We recommend using a water line installation kit that contains copper tubing and a ¼" compression nut. 3. Connect the water line installation kit to the shut off valve. Cold water line Pipe clamp Shut off valve Water line installation kit CAUTION The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the filter to malfunction. Connecting the water supply line to the refrigerator There are several items that you need to purchase to complete this connection. You may find these items sold as a kit at your local hardware store. Connecting to the water supply line 1. First, shut off the main water supply. Use Copper Tubing • ¼" copper tubing • ¼" compression nut (1pc) • Ferrule (2pc) Use Plastic Tubing • ¼" plastic tubing → Molded end (Bulb) • ¼" compression nut (1pc) 2. Locate the nearest cold water drinking line and install the pipe clamp and shut off valve. Cold water line Pipe clamp Shut off valve English - 17