Samsung RF23HSESBSR User Manual Ver.03 (English, French, Spanish) - Page 43

operating 5. Flex Zone -- To remove the Flex Zone : Pull the Flex door out to full extension. Then, lift the Flex Zone up, pulling it to your body with both hands. -- To re-install the Flex Zone : Open the Flex door to full extension. Tilt the front of the Flex Zone up, place the back of the Flex Zone onto the rails, and then lower the front until the whole Zone rests on the rails. Using the doors Ensure that the doors close all the way and are securely sealed. When the refrigerator door is only partially open, it will automatically close. If the the door is opened more than its auto close range, it will remain open. You must close it manually. If the Flex Zone or LED lighting is not working, check the connectors [ ( 1 ), ( 2 ) shown below ] for cracks or leaks. (2) REMOVING THE FREEZER ACCESSORIES 1. Freezer Room Guard -- To remove : Remove the freezer room guard ( 1 ) by lifting the guard up. -- To re-install : Push down until the guard ( 1 ) locks into place. (1) 2. Super Extended Drawer -- To remove : Pull the drawer out to full extension. Tilt up the rear of the drawer and lift straight out. -- To re-install : Place the drawer onto the rails ( 4 ) by tilting it up. Lower the drawer into place until it is horizontal and slide the Drawer ( 3 ) in. 4 (1) 3 1. Disassemble the Flex Door. Refer to to page 13 for disassembly instructions. 2. Open the cover rail cap with a flat-blade screw driver to examine the connectors. English - 43