Samsung SHR-5042 User Manual - Page 31

 )%%
'PSNBU When initializing the HDD, move the cursor to the corresponding HDD and press the &OUFS( ) button. Then, the (Format) icon is activated. If you press "'PSNBU", the HDD format window appears. You can select "0," to initialize the HDD.  )%%
&/% 4UPQ: Recording stops when the HDD becomes full while in recording. 0WFS8SJUF: If the HDD becomes full while in recording, the data recorded at the earliest time will be deleted and new data will be written. 3.
0O: If the HDD becomes full while in recording, it gives an alarm. 0GG: If the HDD becomes full while in recording, it does not give any alarm.  If the HDD space is not enough, the Disk_Full ( ) icon appears.  Because all data will be deleted when the HDD formatting is executed, please Caution proceed with the initialization after backing up important data to other place.  If the repeated HDD recording is set to "0WFS8SJUF" and the data to be backed up are overwritten, either the backup start time can be changed or the backup is cancelled. Checking HDD Data Caution Please, pay attention to Following information to minimize the chance of losing HDD data.  Remember that you should protect HDD from any impact or misuse as this may cause damaged.  The Manufacturer is not responsible for missing data or defects caused by the user's mishandling. /PUF: Adding Extra HDD. Check in advance that the HDD is compatible with the manufacturer's DVR. Examples that can cause loss of data or damage HDD.  Any outside Impact on the case which could happen whilst disassembling or setting up the DVR.  Power cut or incorrect shutdown whilst the DVR is operating. (Refer to page 27: how to turn off DVR)  Moving or causing any impact on the DVR during operation. Please, back up events as soon as possible to minimize disappointment should HDD data be lost. SHR-5042_Eng.indb 27 05 MENU SETUP System Shutdown System Shutdown Sure to shutdown? Move/Control OK Cancel Select Exit This function is used when either terminating the running jobs safely or turning off the power. If you see the system shutdown message after pressing "0," on the confirmation window, turn off the power.  If the system is turned off without terminating it using the system shutdown Caution menu, it may cause a problem such as data loss and disk failure. When turning off the power, please terminate the system first using the system shutdown menu. CAMERA The details of the camera menu are as follows: SHR-5042/5040 MENU System ► Camera ► Camera Configuration Monitoring Record Mode ► PTZ Device Screen Setup Event Record ► Record Schedule Backup Network ► Move/Control Select Exit menu setup _27 2007-06-08 1:24:46