Sanyo SYSZ5LMP PLV-Z5 Owners Manual - Page 50
Indicators and Projector Condition
UPC - 017133340781
View all Sanyo SYSZ5LMP PLV-Z5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Appendix Indicators and Projector Condition Check the indicators for projector's condition. Indicators POWER LAMP red/green/ WARNING REPLACE orange red yellow Projector Condition The Main On/Off switch is off or the AC power cord is unplugged. ✽ The projection lamp is being cooled down. The projector cannot be turned on until cooling is completed. ✽ The projector is ready to be turned on with the POWER ON/STAND-BY button. ✽ The projector is operating normally. ✽ The projector is in the Power management mode. The temperature inside the projector is abnormally high. The projector cannot be turned on. When the projector is cooled down enough and the ✽ temperature returns to normal, the POWER indicator emits red light and the projector can be turned on. (The WARNING indicator keeps blinking.) Check and clean the air filters. The projector has been cooled down enough and the inside temperature ✽ returns to normal. When turning on the projector, the WARNING indicator stops blinking. Check and clean the air filters. The projector detects an abnormal condition and cannot be turned on. Unplug the AC power cord and plug it again to turn on the projector. If the ✽ projector is turned off again, unplug the AC power cord and contact the dealer or service center for servicing and checkup. Do not leave the projector on. It may cause an electric shock or a fire hazard. The lamp does not turn on because malfunction occurs or the lamp reaches its end of life. ✽ The automatic slide shutter is not working properly. • • • green red • • • blinking green blinking red • • • blinking orange blinking yellow • • • off * When the projection lamp reaches its end of life, the LAMP REPLACE indicator lights yellow. When this indicator becomes yellow, replace the projection lamp with a new one promptly. Reset the Lamp replacement counter after replacing the lamp. The time when the LAMP REPLACE indicator should light is depending on the lamp mode. See pages 47 - 48. 50