Sanyo WTC500L Owner's Manual - Page 20
Connecting to a Computer (Digital and Analog RGB), Cables used for connection
UPC - 086483074257
View all Sanyo WTC500L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Installation Connecting to a Computer (Digital and Analog RGB) * Cables used for connection )( =Cables are not supplied with this projector.) • VGA Cable (Mini D-sub 15 pin) (One cable is supplied)* • HDMI-DVI Cable * • Serial Control Cable * • BNC Cable * • USB Cable * USB port Monitor Output DVI Output Monitor Output Monitor Input Serial Output USB cable BNC cable HDMI-DVI cable VGA cable VGA cable Serial Control Cable USB G B R H/V V HDMI ANALOG IN MONITOR CONTROL OUT PORT ✔Notes: • USB cable connection is needed when operating the computer with the remote control. • When the Standby mode is set to "Eco" in the Setting, MONITOR OUT and AUDIO OUT are disabled. (p.56) • See page 84 for ordering optional cables. Unplug the power cords of both the projector and external equipment from the AC outlet before connecting cables. ✔Notes: • When DVI signal is connected to HDMI terminal with HDMI-DVI cable, connect the sound signal to AUDIO1 and set up Sound of "HDMI setup" to "AUDIO1". (p.58) • This projector can be connected to the corresponding equipment of DVI however depending on the equipment there are the cases it does not operate normally ; the image does not appear and the sound is not output. 20