Sanyo WTC500L Owner's Manual - Page 50

Setting Capture This function enables you to capture an image being projected to use it for a starting-up display or interval of presentations. Select Capture and press the SELECT button. A confirmation box appears and select [Yes] to capture the projected image. After capturing the projected image, go to the Logo select function and set it to "User". Then the captured image will be displayed the next time you turn on the projector. To cancel the Capture function, select [No]. Capture Select [Yes] to capture the projected image. ✔Notes: • Before capturing an image, select "Standard" in the Image Menu to capture a proper image (p.41). • A signal from a computer can be captured up to WXGA (1280 x 800). A signal from video equipment can be captured except for 720p, 1035i, and 1080i. • When capturing the image that has been adjusted by the Keystone function, the adjusted data is automatically reset and the projector captures an image without keystone correction. • When the Logo PIN code lock function is set to "On," the Capture function cannot be selected. • When starting to capture a new image, the previously stored image is cleared even if you cancel the capturing. • "User" cannot be selected when the image is not captured. Select [Yes] to stop capturing. Logo PIN code lock This function prevents an unauthorized person from changing the screen logo. Off The screen logo can be changed freely from the Logo Menu (p.51). On The screen logo cannot be changed without a Logo PIN code. If you want to change the Logo PIN code lock setting, press the SELECT button and the Logo PIN code dialog box appears. Enter a Logo PIN code by following the steps below. The initial Logo PIN code is set to "4321" at the factory. Logo PIN code lock 50