Sanyo WTC500L Owner's Manual - Page 23
Connecting the AC Power Cord, NOTE ON THE POWER CORD, Projector side, AC outlet side, CAUTION
UPC - 086483074257
View all Sanyo WTC500L manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Connecting the AC Power Cord This projector uses nominal input voltages of 100-120 V or 200-240 V AC and it automatically selects the correct input voltage. It is designed to work with single-phase power systems having a grounded neutral conductor. To reduce the risk of electrical shock, do not plug into any other type of power system. If you are not sure of the type of power being supplied, consult your authorized dealer or service station. Connect the projector with all peripheral equipment before turning the projector on. CAUTION The AC outlet must be near this equipment and must be easily accessible. ✔Note: •U nplug the AC power cord when the projector is not in use. When the projector is connected to an outlet with the AC power cord, it is in stand-by mode and consumes a little electric power. Installation Connect the AC power cord (supplied) to the projector. NOTE ON THE POWER CORD AC power cord must meet the requirements of the country where you use the projector. Confirm the AC plug type with the chart below and proper AC power cord must be used. If the supplied AC power cord does not match your AC outlet, contact your sales dealer. Projector side For the U.S.A. and Canada Ground AC outlet side For Continental Europe For the U.K. To power cord connector on your projector. To the AC outlet. (120 V AC) To the AC outlet. (200-240 V AC) To the AC outlet. (200-240 V AC) 23