Sharp AL 800 AL-800 AL-840 Operation Manual - Page 42

STATUS INDICATORS When any of following indicators light up or blink on the operation panel or the following alphanumeric codes appear in the display, solve the problem by referring to both the table below and the relevant page. Be sure to use only genuine SHARP parts and supplies. Indication Cause and remedy See page: Steadily Replacement of drum cartridge will be needed 44 Drum replacement lit soon. Obtain a new cartridge. required indicator Blinking Drum cartridge must be replaced. Replace it with a new one. 29 TD cartridge replacement Steadily Replacement of TD cartridge will be needed 44 lit soon. Obtain a new cartridge. required indicator Blinking TD cartridge must be replaced. Replace it with a new one. 28 A misfeed has occurred. Remove the misfed 34 Misfeed indicator Blinking paper referring to the description of "Misfeed removal." "CH" is blinking in the display. The TD cartridge is not installed. Check if the 28 6 cartridge is installed. Copier trouble? "CH" is steadily lit in the Front cover is open. Close the front cover - display. securely. Paper tray is empty. Load copy paper. 14 "P" is blinking in the display. A misfeed has occurred in the paper tray. 34 Remove the misfed paper. The copier will not function. Turn the power - A letter and a number appear switch off, remove the power cord from the alternately. outlet, and contact your SHARP service center. DISPLAYING TOTAL NUMBER OF COPIES Use the following procedure to display the total number of copies. 1 Press the clear ( ) key to reset the display to zero. 2 Press and hold down the clear ( ) key for approximately 5 seconds. The total number of copies will appear in two steps, each with three digits. Example: Total number of copies is 1,234. 41