Sharp LC-46D64U LC-42D64U LC-46D64U LC-52D64U Operation Manual - Page 8

Supplied accessories Make sure the following accessories are provided with the product. Remote control unit "AAA" size battery (g1) (g2) Page 8 Page 8 AC cord (g1) Page 7 Cable clamp (g1) Cable tie (g1) Page 7 Stand unit (g1) Page 6 Operation manual (g1) NOTE • Always use the AC cord supplied with the TV. • AC cord enclosed in this product is for 110-125V. In using it on the 125-240V AC, please consult to the following. SHARP ELECTRONICS CORPORATION, LATIN AMERICA GROUP 6100 Blue Lagoon Drive, Suite 150, Miami, Florida 33126, U.S.A. QUICK REFERENCE Attaching the stand • Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal. • Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged. CAUTION • Attach the stand in the correct direction. • Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over. 1 Confirm that there are 8 screws (4 short screws and 4 long screws) supplied with the stand unit. 3 1 Insert the stand into the openings on the bottom of the TV. 2 Insert and tighten the 4 short screws into the 4 holes on the rear of the TV. Hex key 2 Attach the supporting post for the stand unit onto the base using the box for the stand unit as shown below. • The supporting post attaches to the base at an off-centered location on the base. Be sure to attach the supporting post in the direction indicated below and attach the stand to the TV with the wider side of the base facing forward. Hex key Long screws 2 Short screws 2 Soft cushion Forward 6 1 1 NOTE • To detach the stand, perform the steps in reverse order.