Sharp PG-B10S Operation Manual - Page 23
Switching the INPUT Mode, Adjusting the Volume, Press, on the remote
UPC - 074000364080
View all Sharp PG-B10S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Projection Switching the INPUT Mode Select the appropriate input mode for the connected equipment. Press , or on the remote control to select the INPUT mode. •When pressing on the projector, input mode switches in order of INPUT 1 INPUT 2 INPUT 3 . Note • When no signal is received, "NO SIGNAL" will be displayed. When a signal that the projector is not preset to receive is received, "NOT REG." will be displayed. • The INPUT mode is not displayed when "OSD Display" of the "Options" menu is set to "OFF". (See page 41.) About the INPUT mode INPUT 1 Used for projecting images from (RGB/ equipment that sends RGB sig- Component) nals or component signals con- nected to the RGB input terminal. INPUT 2 Used for projecting images (S-Video) from equipment connected to the S-VIDEO input terminal. INPUT 3 (Video) Used for projecting images from equipment connected to the VIDEO input terminal. INPUT buttons "On-screen Display of INPUT Mode (Example) INPUT 1 mode Using RGB Using Component INPUT 2 mode Using S-Video INPUT 3 mode Using Video ➝ ➝ ➝ Adjusting the Volume Press or on the remote control to adjust the volume. Note • Pressing will lower the volume. Pressing will raise the volume. • On the projector, the volume can be ad- justed by pressing or . Volume buttons -19