Sharp PG-B10S Operation Manual - Page 49
Password (Setting a Password), If You Forget Your Password, Old Password - buttons locked
UPC - 074000364080
View all Sharp PG-B10S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Password (Setting a Password) A password must be set to activate the "AntiTheft" function (Page 46). There is no factory preset for the password or the "Anti-Theft" settings. In this way, anyone can freely set a new password and "Anti-Theft" settings. It is therefore recommended that even if you do not want to use the "Anti-Theft" function, you at least set a password to prevent others from setting the "Anti-Theft" function. Select "Password" on the "Options" menu, then press and follow the procedure below to enter the password. Setting the menu screen Page 34 1 Press ' or " to select the desired number and then press |. 2 Enter the 3 remaining digits and press . 3 Enter the password again in "Re- confirm" and press . If you want to change the password, follow the procedure below. 1 Press ', " and | to enter the password in "Old Password" and press . 2 Press ', " and | to set the new password and press . 3 Enter the new 4-digit password again in "Reconfirm" and press . Note • If you do not want to set a password, leave the fields in steps 2 and 3 blank and press . • To cancel the password settings, press . Using the Menu Note • When a password is set, you need to enter the password to change the "Anti-Theft" setting. If You Forget Your Password If you forget the password, delete it using the following procedure and set a new password. Note Press (VOL) (VOL) (VOL) (VOL) . • If is held down for more than 3 seconds, the operation buttons on the projector will be locked. (See page 29.) • You can only use the buttons on the projector to delete the password. • The password cannot be deleted using the above described procedures while the "Anti-Theft" function is set. If you forget your password while the "Anti-Theft" function is activated, you will need to contact your nearest Sharp Autho- rized Projector Dealer or Service Center (see page 73). You may need to bring your projector to them to restore the projector to original factory condition (password and keycode reset). -45