Sharp PG-B10S Operation Manual - Page 25
Turning the Power off (Putting the Projector into the Standby Mode), the Keystone Correction. - no power
UPC - 074000364080
View all Sharp PG-B10S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
2 Press ', ", \ and | to adjust the Keystone Correction. • You can also adjust the Keystone Cor- rection using the , , and buttons on the projector. Note • Press to return to the default setting. • Straight lines or the edges of images may appear jagged while adjusting the image. 3 Press . • The on-screen display of the Keystone Correction mode will disappear. • You can also use on the projector. Note • You can use the same settings used in NORMAL mode 4:3 for 16:9. Compresses upper side. Compresses lower side. Projection Turning the Power off (Putting the Projector into the Standby Mode) 1 Press on the projector or STANDBY on the remote control, then press that button again while the confirmation message is dis- played, to put the projector into the standby mode. STANDBY button Note • If you accidentally pressed STANDBY or and do not want to put the pro- jector into the standby mode, wait until the confirmation message disappears. 2 Unplug the power cord from the AC outlet after the cooling fan stops. Info • Do not unplug the power cord during projection or cooling fan operation. The cooling fan in this projector continues to run for about 90 seconds after the projector enters the standby mode. This can cause damage due to rise in internal temperature, as the cooling fan also stops. -21