Sharp PG-B10S Operation Manual - Page 27
Using the Adjustment Feet, Press HEIGHT ADJUST button.
UPC - 074000364080
View all Sharp PG-B10S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Using the Adjustment Feet The height of the projector can be adjusted using the adjustment feet at the front and rear of the projector. When the screen is in a higher position than the projector, the projection image can be made higher by adjusting the projector. 1 Press HEIGHT ADJUST button. • The front adjustment foot comes out. 2 Lift the projector to adjust its height while pressing the HEIGHT ADJUST button. • The projector is adjustable up to approximately 12 degrees (5 steps). • When lowering the projector, it may be difficult to move the front adjustment foot because the installation surface is difficult to slide. In this case, pull the projector back slightly and adjust its height. 3 Remove your hands from the HEIGHT ADJUST button of the projector after its height has been finely adjusted. 4 Use the rear adjustment foot to make the projector level. • The projector is adjustable ±1 degree from the standard position. Note • When the height of the image is being adjusted by the adjustment feet, the image becomes distorted trapezoidally. In this case, see "Correcting Trapezoidal Distortion" on the page 20 to correct the trapezoidal distortion. Info • Do not press the HEIGHT ADJUST button when the front adjustment foot comes out without firmly holding the projector. • Do not hold the lens when lifting or lowering the projector. • When lowering the projector, be careful not to get your fingers caught in the area between the adjustment foot and the projector. HEIGHT ADJUST button Front adjustment HHEEIGIGHTHATDAJUDSJTUbSuTttobnutton foot Rear adjustment foot -23 Projection