Sharp XE-A406 XE-A406 Operation Manual in English and Spanish - Page 81
Error message table, Before Calling for Service - not assigned error
UPC - 074000049536
View all Sharp XE-A406 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
9 Before Calling for Service The malfunctions shown in the left-hand column below, labeled "Problem," do not necessarily indicate functional faults of the machine. It is therefore advisable to refer to "Solution" shown in the right-hand column before calling for service. Problem (1) The display shows symbols that do not make sense. (2) The display won't illuminate even when the mode switch is turned to any other position than "OFF". (3) The display is illuminated, but the whole machine refuses registrations. (4) No receipt is issued. (5) No journal paper is taken up. (6) Printing is unusual. Solution • Has the machine been initialized properly as shown in "GETTING STARTED"? (Note that initialization clears all the data and programmed settings stored in memory.) • Is power supplied to the electrical outlet? • Is the power cord plug out or loosely connected to the AC outlet? • Is a clerk code assigned to the register? • Is the mode switch set properly at the "REG" position? • Is the paper roll properly installed? • Is there a paper jam? • Is the receipt function in the "OFF" status? • Is the print head release lever at the printing position? • Is the take-up spool installed on the bearing properly? • Is there a paper jam? • Is the print head release lever at the printing position? • Is the paper roll properly installed? Error message table l When the following error messages are displayed, press the key and take a proper action according to the table below. Error message Error status Action ENTRY ERROR MISOPERATION NO RECORD MEMORY FULL SBTL COMPUL. TEND COMPUL. NOT ASSIGNED OVER LIMIT. INH. OPEN PR INH. UNIT PR NOT NON-TEND BUFFER FULL HEAD UP PAPER EMPTY Registration error Misoperation error Undefined code is entered. a Memory is full (in the key programming). s Compulsory depression of the key for direct finalization Compulsory tendering No entry of a clerk code Overflow limitation error The open price entry is inhibited. The preset price entry is inhibited. The direct finalization is inhibited. Subtotal void is not allowed. Print head release lever is lifted up. Receipt and/or journal paper roll is not installed or empty. Make a correct key entry. Make a correct key entry. Enter a correct code. a Program the key within 25 steps. s Press the key and continue the operation. Make a tendering operation. Make a clerk code entry. Make a registration within a limit of entry. Make a preset price entry. Make an open price entry. Make a tendering operation. Finalize the transaction, and correct the wrong entries in the void mode. Move the lever toward the take-up spool (to the printing position). Install a receipt and/or journal paper. 79