Singer One Instruction Manual 2 - Page 53
Embroidery
View all Singer One manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
51 To Use the Darning Foot for Embroidery or Darning Put on the feed cover plate No. 66628 (A, Fig. 49). Turn the balance wheel over toward you until the take-up lever is at its highest point. Remove the E 1162 7 FIG. 49. MACHINE THREADED FOR EMIalOIDERY AND DARNING presser foot (F. Fig. 15, page 17), and attach the darning foot No. 121094 to the presser bar by means of the presser foot thumb screw as shown above. Lower the presser bar and move the darning foot up or down on the presser bar until there is just room for the material to move freely between the bottom of the foot and the feed cover plate, then tighten the thumb screw. Thread the machine in the usual way, passing the thread down through the hole (B) in the darning foot. Having placed the work to be darned or embroidered on a SINGER Darner or in two embroidery hoops, raise the presser bar and place the work under the needle as shown in Fig. 50, then lower the presser bar. Holding the needle thread in the usual way with the finger and thumb of the left hand, turn the balance wheel over toward you with the right hand to draw up the bobbin thread.