Sony DG910 Instructions Manual - Page 86
To cancel programming, To activate the input after
UPC - 027242707023
View all Sony DG910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
4 Press ENTER. Once the numeric code has been verified, the RM SET UP indicator slowly flashes twice and the remote automatically exits the programming mode. 5 Repeat steps 1 to 4 to control other components. Notes • The indicator turns off while a valid button is pressed. • In step 2, if several input buttons are pressed, only the last pressed button is valid. • In step 2, if you press TUNER, you can only program the button to control a tuner (page 90). • In step 3, if an input button is pressed, the new input is selected and the programming procedure returns to the beginning of step 3. • For the numeric codes, only the last three numbers entered are valid. To program the remote to control a TV 1 Press RM SET UP. The RM SET UP indicator slowly flashes. 2 Press TV. 3 Press the numeric buttons to enter the numeric code (or one of the codes if more than one code exists) for TV. For details, see page 88. 4 Press ENTER. Once the numeric code has been verified, the RM SET UP indicator slowly flashes twice and the remote automatically exits the programming mode. To cancel programming Press RM SET UP during any step. The RM SET UP indicator flashes 5 times in quick succession. The remote automatically exits the programming mode. To activate the input after programming Press the programmed button to activate the input you want. If programming is unsuccessful, check the following: • If the indicator does not light up in step 1, the batteries are weak. Replace both batteries. • If the indicator flashes 5 times in quick succession while entering the numeric code, an error has occurred. Start again from step 1. To clear the memory of the remote To clear all programmes, do the following to reset the remote to factory settings. While holding down MASTER VOL -, press and hold ?/1 and then press AV ?/1. The indicator flashes 3 times, then goes off. The numeric codes corresponding to the component and the maker of the component Use the numeric codes in the tables below to control non-Sony components and also Sony components that the remote is normally unable to control. Since the remote signal that a component accepts differs depending on the model and year of the component, more than one numeric code may be assigned to a component. If you fail to program your remote using one of the codes, try using other codes. Notes • The numeric codes are based on the latest information available for each brand. There is a chance, however, that your component will not respond to some or all of the codes. • All of the input buttons on this remote may not be available when used with your particular component. 86US