Sony DVP-NC800H/S Operating Instructions - Page 23
Press ENTER., Dolby Digital signal you wish
View all Sony DVP-NC800H/S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Hookups 8 Press ENTER. The Setup Display for selecting the type of jack used to connect your audio component such as an amplifier (receiver) appears. Is this player connected to an amplifier (receiver)? Select the type of jack you are using. YES LINE OUTPUT L/R(AUDIO) DIGITAL OUTPUT NO 9 Press X/x to select the type of jack (if any) you are using to connect to an audio component, then press ENTER. If you did not connect an audio component, select "NO," then go to step 13. If you connected an audio component using just an audio cord, select "YES: LINE OUTPUT L/R (AUDIO)," then go to step 13. If you connected an audio component using a digital coaxial or optical/HDMI cord, select "YES: DIGITAL OUTPUT." 10Press X/x to select the type of Dolby Digital signal you wish to send to your audio component. If your audio component has a Dolby Digital decoder, select "DOLBY DIGITAL." Otherwise, select "D-PCM." AUDIO SETUP AUDIO DRC: STANDARD DOWNMIX: DOLBY SURROUND DIGITAL OUT: ON DOLBY DIGITAL: D-PCM DTS: D-PCM 48kHz/96kHz PCM: DOLBY DIGITAL 11Press ENTER. "DTS" is selected. AUDIO SETUP AUDIO DRC: STANDARD DOWNMIX: DOLBY SURROUND DIGITAL OUT: ON DOLBY DIGITAL: D-PCM DTS: OFF 48kHz/96kHz PCM: OFF ON 12Press X/x to select whether or not you wish to send a DTS signal to your audio component. If your audio component has a DTS decoder, select "ON." Otherwise, select "OFF." 13Press ENTER. Quick Setup is finished. All connections and setup operations are complete. Note When "PhotoTV HD" mode is activated (page 51), the selection for "TV TYPE" is skipped. 23US