Sony HDWS280 Product Manual (Operation Manual 1st Edition (Revised 5)) - Page 54
Erasing the Stop Code
View all Sony HDWS280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Adjusting the stop position by modifying the starting point for recording a stop code You can modify the position at which to start recording the stop code by 1 to 5 seconds in units of seconds with REC ADJUST, a submenu of setup menu item 138. For details on setup menu item 138, see page 67. Tape running direction 5 seconds before 1 second before SOM Stop code Stop code Stop position adjustable range 7-2-3 Erasing the Stop Code The tape is prerolled to five seconds before the point where the stop code is recorded, and erasing of the stop code begins. When erasing the stop code is finished, the setting made in step 2 is automatically set to OFF. When a stop code is being erased, the menu for the timecode required for recording the stop code is selected independently of the settings for TCG and PRST/RGN on the P4 TC page of the function menu. To interrupt the operation Press the STOP button. Checking stop code erasure Press the CHECK function button on the STOPCODE page together with the SHIFT button. The tape is prerolled to five seconds before the point where the stop code is record, and playback starts. If the tape stops at the position where the stop code was recorded, the erasure operation must be performed again. Erasing the stop code Proceed as follows. Function button Menu display area HDW-S280 EJECT PB LEVEL 13 REC LEVEL 13 24 24 R/P LEVEL CTL VAR LEVEL PRESET PHONES REC INHI ON OFF KEY INHI ON OFF SHIFT PAGE HOME CHARACTR ON PB/EE PB CONFI ENABLE CTL/TC TC EMPH EMPH EMPH EMPH 0 0 -10 -10 -20 -20 -30 -30 -40 -40 1 23 4 HD INPUT : ANA CH1 IN : -60 CH2 IN : -4 COND OUT : +4 MONI L : 1 BANK 2 MONI R : 2 D-STOP DOLBY NR P ROLL ASSEMBLE 59.94i SDI ASMBL CONFI ON RECORDER OFF LTC DF VITC LTC EXT-LTC R-RUN REM:00M TCG SET HOME 00:00:00:00. DISPLAY MULTI CONTROL REMOTE MENU RESET PREROLL PUSH PITCH CTL JOG/SHUTTLE REW PLAY F FWD STOP REC PAUSE STANDBY SHIFT button STOP button 1 Select STOPCODE on the P6 OTHER page of the function menu. The STOPCODE page appears. 2 Press the REC/ERAS function button to set ERASE. 3 Play the range including the stop code to be erased from the tape. The tape stops when the stop code is detected. 4 Press the ERASE function button on the STOPCODE page together with the SHIFT button. Chapter 7 Stop Code 54 Stop Code Operation