Sony HT-M5 Operating Instructions - Page 58
BRAVIA Sync Control for, Remote control, Error messages, Preparing for the BRAVIA Sync
View all Sony HT-M5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
• Playback is possible up to 8 levels (including "ROOT" folder). • The number of folders has exceeded 100 (including "ROOT" folder). • The number of files in a folder has exceeded 100. • Files that are encrypted or protected by passwords, etc. cannot be played back. * This receiver supports FAT16 and FAT32, but some USB device may not support all of these FAT. For details, refer to the operating instruction of each USB device or contact the manufacturer. "BRAVIA" Sync (Control for HDMI) The Control for HDMI function does not work. • Check the HDMI connection (page 25). • Make sure "CTRL.HDMI" is set to "CTRL ON" in the HDMI menu. • Make sure the connected equipment is compatible with the Control for HDMI function. • Check the Control for HDMI settings on the connected equipment. Refer to the operating instructions of the connected equipment. • If you unplug the HDMI cable or change the connection, repeat the procedures of "Preparing for the "BRAVIA" Sync" (page 43). • When "CTRL.HDMI" is set to "CTRL OFF", the "BRAVIA" Sync does not work properly, even if a equipment is connected to the HDMI IN jack. • The types and the number of equipment which can be controlled by the "BRAVIA" Sync are restricted in the HDMI CEC standard as follows. - Recording equipment (Blu-ray Disc recorder, DVD recorder, etc.): up to 3 equipment - Playback equipment (Blu-ray Disc player, DVD player, etc.): up to 3 equipment 58US - Tuner-related equipment: up to 4 equipment - AV receiver (audio system): up to 1 equipment Remote control The remote control does not function. • Point the remote control at the remote control sensor on the receiver (page 7). • Remove any obstacles in the path between the remote control and the receiver. • Replace all the batteries in the remote control with new ones, if they are weak. • Make sure you select the correct input on the remote control. Error messages If there is a malfunction, a message appears on the display panel. You can check the condition of the system by the message. If any problem persists, consult your nearest Sony dealer. If an error message appears while you use a USB device, see "USB message list" (page 36). PROTECT Irregular current is output to the speakers, or the receiver is covered and ventilation holes are blocked. The receiver will automatically turn off after a few seconds. Remove the object covering the upper panel of the receiver, check the speaker connection, and turn on the power again. USB FAIL An over current from the (USB) port was detected. The receiver will automatically turn off after a few seconds. Check the USB device, then unplug it and turn on the power again.