Sony KDF E60A20 Operating Instructions - Page 35
VCR and Cable Box, S VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN input - remote control
UPC - 027242675339
View all Sony KDF E60A20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Connecting the TV Connecting the TV VCR and Cable Box Before connecting a cable box, see "Using CableCARD Device" on page 25. Use this hookup if: ❑ Your cable TV company scrambles some channels, but not all of them (pay channels vs. regular cable channels) and you need to use a cable box. With this setup you can: ❑ Use the TV's remote control to change channels on your cable box when the signal is scrambled. To program your Sony remote control to operate your cable box, see "Programming the Remote Control" on page 44. ❑ Use the TV's remote control to change channels on your TV when the signal is not scrambled. Your TV's tuner provides a better picture quality than the output of your cable box. Disconnect all power sources before making any connections. 1 Connect the CATV cable to the single (input) jack of the splitter. 2 Use a coaxial cable to connect one of the splitter's two output jacks to the TV's CABLE jack. 3 Use a coaxial cable to connect the splitter's other output jack to the cable box's input jack. 4 Use a coaxial cable to connect the cable box's output jack to the VCR's RF input jack. 5 Use an A/V cable to connect the cable box's A/V output jacks to the TV's A/V input jacks. 6 Use an A/V and S VIDEO cables to connect the VCR's AUDIO and S VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN input jacks. 7 Run Auto Program, as described in "Setting Up the TV Channel List" on page 30. ✍ To view scrambled channels, tune the TV to the channel the cable box is set to (usually channel 3 or 4) and then use the cable box to switch channels. (Continued) 33