Sony KE-42M1 Operating Instructions (primary manual) - Page 14

Programming the Remote Control 5 DVD/ SAT/ POWER MUTING VCR CABLE MODE PICTURE WIDE SLEEP DISPLAY 3 4 FREEZE FAVORITES MENU TOP MENU F1 F2 TV VIDEO 1/2/3 VIDEO 4 VIDEO 5 1, 2 RESET PIC OFF MTS/SAP GUIDE TV/SAT 1 The remote control is preset to operate Sony brand video equipment. Sony Equipment DVD/VCR SAT/Cable Programmable Code Number 701 (Sony Dream System) 801 (Satellite Cable Box) If you have video equipment other than Sony brand that you want to control with the TV's remote control, use the following procedures to program the remote control. Note The equipment must have infrared (IR) remote capability in order to be used with this remote control. From the "Manufacturer's codes" listed on page 15, select the three-digit code number for the manufacturer's code of your equipment. If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment. Use the code number to complete the following procedure. 1 Press the DVD/VCR (FUNCTION) and RESET buttons simultaneously, or press the SAT/ CABLE (FUNCTION) and RESET buttons simultaneously. 2 Press the function button you want to program. To program a cable box or a satellite receiver Press SAT/CABLE (FUNCTION). To program video equipment Press DVD/VCR (FUNCTION). 3 Enter the three-digit manufacturer's code number using the 0-9 buttons. 4 Press ENT (enter). 5 To check if the code number works, aim the TV's remote control at the equipment and press DVD/VCR and/or SAT/CABLE (POWER) that corresponds with that equipment. If it responds, the programming is completed. If not, try using the other codes listed for that manufacturer. Tips • If you enter a new code number, the code number you previously entered at that setting is erased. • In some rare cases, you may not be able to operate your equipment with the Sony remote control. In this case, use the equipment's own remote control unit. 14