Sony KE-42M1 Operating Instructions (primary manual) - Page 25

Connecting and Setting the TV Connecting a Satellite Receiver and a VCR Disconnect all power sources before making any connections. 1 Connect the satellite antenna cable to the satellite receiver's SATELLITE IN jack. 2 Connect the CATV cable to the VCR's VHF/UHF IN jack. 3 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT jack to the TV's VHF/UHF jack. 4 Using AUDIO and S VIDEO cables, connect the satellite receiver's AUDIO and S VIDEO OUT jacks to the VCR's AUDIO and S VIDEO IN jacks. 5 Using AUDIO and S VIDEO cables, connect the VCR's AUDIO and S VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks (VIDEO IN 1 or 3). Satellite receiver S VIDEO cable (not supplied) VCR CATV cable Satellite antenna cable AUDIO cable (not supplied) S VIDEO VIDEO (yellow) AUDIO-L (white) AUDIO-R (red) 75-ohm coaxial cable (supplied) Rear of TV VIDEO IN 1 3 S VIDEO VIDEO L(MONO) AUDIO R HD/DVD IN 4 Y PB PR L AUDIO R VHF/UHF CENTER SPEAKER IN 180W (6 ) MAX L(MONO) AUDIO R AUDIO OUT (VAR/FIX) 75-ohm coaxial cable (supplied) S VIDEO cable (not supplied) AUDIO cable (not supplied) Note When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make sure "Auto YC" in the (Setup) menu is set to "On" to view the S VIDEO input (see page 23). Tips • You can also use the VIDEO IN 2 jacks located on the front of the TV to connect your VCR. • Be sure your VCR's video input is set correctly. Consult your VCR's operating manual for instructions. • Use VIDEO 1/2/3 on the remote control to select VIDEO IN 1 (or VIDEO IN 3 if you use the VIDEO IN 3 jacks for this hookup) to watch satellite TV or to watch a tape on the VCR (your VCR must be turned on). • If your VCR or satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S VIDEO cable. 25