Sony PCV-J150 System Reference Manual (primary manual) - Page 90

78 VAIO® Reference Manual PCI Configuration Status and Error Messages The following is a list of status and error messages that may appear on your system from time to time. Message Floppy Disk Controller Resource Conflict CMOS Checksum Error, CMOS Cleared CMOS Data Invalid, CMOS Cleared Parallel Port Resource Conflict PCI Error Log is Full PCI I/O Port Conflict PCI IRQ Conflict PCI Memory Conflict Primary Boot Device Not Found Primary IDE Controller Resource Conflict Primary Input Device Not Found Primary Output Device Not Found Secondary IDE Controller Resource Conflict Serial Port 1 Resource Conflict Static Device Resource Conflict System Board Device Resource Conflict Meaning The diskette controller has requested a resource that is already in use. The CMOS data was reinitialized due to a CMOS checksum error. Invalid entry in the CMOS. The parallel port has requested a resource that is already in use. This message is displayed when more than 15 PCI conflict errors are detected. No additional PCI errors can be logged. Two devices requested the same resource, resulting in a conflict. Two devices requested the same resource, resulting in a conflict. Two devices requested the same resource, resulting in a conflict. The designated primary boot device (hard disk drive, diskette drive, CD-ROM drive, or network drive) could not be found. The primary IDE controller has requested a resource that is already in use. The designated primary input device (keyboard, mouse, or other, if input is redirected) could not be found. The designated primary output device (display, serial port, or other, if input is redirected) could not be found. The secondary IDE controller has requested a resource that is already in use. Serial port 1 has requested a resource that is already in use. A device has requested a resource that is already in use. A device has requested a resource that is already in use.