Sony STR-DA3400ES Operating Instructions (Large File - 15.18 MB) - Page 122
Programming the remote, To cancel programming
View all Sony STR-DA3400ES manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Programming the remote You can customize the remote to match the components connected to your receiver. You can even program the remote to control nonSony components and also Sony components that the remote is normally unable to control. The procedure below uses an example in which a VCR made by a company other than Sony is connected to the VIDEO 1 IN jacks on the receiver. Before you begin, note that: - You cannot change the settings of PHONO. - The remote can control only components that accept infrared wireless control signals. Be sure to turn on the receiver and point the remote towards the receiver when performing the following procedure. 1 THEATER SHIFT TV ZONE AMP 2,3 1 2 3 TV INPUT VIDEO1 VIDEO2 BD DVD 4 SAT 7 TUNER -/-- 5 TV 8 PHONO 0/10 6 WIDE MD/ TAPE SA-CD/ CD 9 D.TUNING MULTI IN DMPORT ENT/MEM CLEAR HDMI1 HDMI2 HDMI3 HDMI4 XM SIRIUS SOURCE 2CH/ A.DIRECT A.F.D. MOVIE MUSIC INPUT NIGHT 4 1 While holding down RM SET UP, press AV ?/1. The RM SET UP button flashes. 2 While the RM SET UP button is flashing, press the input button (including TV) for the component you want to control. For example, if you are going to control a VCR connected to VIDEO 1 IN jack, press VIDEO1. The RM SET UP and the SHIFT buttons light up. The input button you selected (VIDEO 1) flashes. If you press the button for a component of which you cannot program the remote, such as DMPORT, XM or SIRIUS, etc., the RM SET UP button keeps flashing. 3 Press the numeric buttons to enter the numeric code (or one of the codes if more than one code exists) corresponding to the component and the maker of the component you want to control. The input button you selected in step 2 (VIDEO 1) lights up. (The RM SET UP and SHIFT buttons remains lit.) Note For a TV remote code value, only numbers in the 500's are valid. 4 Press ENT/MEM. Once the numeric code has been verified, the RM SET UP button flashes twice and the remote automatically exits the programming mode. The input button lights off. To cancel programming Press RM SET UP during any step. 122US