Sony TRV950 Operating Instructions - Page 114
Inserting a scene from a VCR - Insert Editing
UPC - 027242607460
View all Sony TRV950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
Inserting a scene from a VCR - Insert Editing 5 REC 4 ZERO SET MEMORY 0:00:00 ZERO SET MEMORY 114 To change the insert end point Press ZERO SET MEMORY again after step 5 to erase the ZERO SET MEMORY indicator and begin from step 3. Using the Remote Commander In step 5, press z REC and MARK simultaneously, then immediately press X. In step 6, press X at the scene where you want to start recording from. Note Pictures and sound recorded on the portion between the insert start and end points will be erased when you insert the new scene. If you insert scenes on the tape recorded on another camcorder (including another DCR-TRV940/TRV950) The pictures and sound may be distorted. We recommend that you insert scenes on a tape recorded on your camcorder. When the inserted picture is played back Pictures and sound may be distorted at the end of the inserted portion. This is not a malfunction. Pictures and sound at the start point and the end point may be distorted in the LP mode. To insert a scene without setting the insert end point Skip steps 3 and 4. Press x when you want to stop inserting. If you press FN The ZERO SET MEMORY indicator is not display. Note on the Remote Commander Your camcorder works in the commander mode VTR 2. Commander modes 1, 2 and 3 are used to distinguish your camcorder from other Sony VCRs to avoid erroneous remote control operation. If you use another Sony VCR in the commander mode VTR 2, we recommend changing the commander mode or covering the sensor of the VCR with black paper.