TEAC CRH227I Owners Manual - Page 42

Troubleshooting If you have problems with your system, look through this chart and see if you can solve the problem yourself before calling your dealer or TEAC service center. General No power e Check the connection to the AC power supply. Check and make sure the AC source is not a switched outlet and that, if it is, the switch is turned on. Make sure there is power to the AC outlet by plugging another item such as a lamp or fan into the outlet. No sound from speakers. e Select the source by pressing the SOURCE button. e Check the connection to the speakers. e Adjust the volume. e Pull out the headphone's plug from the PHONES jack. eIf "MUTE" is blinking, press the MUTING button. The sound is noisy. e The unit is too close to a TV or similar appliances. Install the unit apart from them, or turn them off. Remote control doesn't work. e Press the STANDBY/ON switch to turn the unit on. e If the batteries are dead, change the batteries. e Use remote control unit within the range (5m or 16 ft.) and point at the front panel. e Clear obstacles between the remote control unit and the main unit. e If a strong light is near the unit, turn it off. CD Player Will not play. e Load a disc with label side up. e If the disc is dirty, clean the surface of the disc. e A blank disc has been loaded. Load a prerecorded disc. e Depending on the disc, etc. it may not be possible to play back CD-R/RW discs. Try again with another disc. e You cannot play back unfinalized CD-R/RW discs. Finalize such a disc in a CD recorder and try again. Sound skips. e Place the unit on a stable place to avoid vibration and shock. e If the disc is dirty, clean the surface of the disc. 42 e Don't use scratched, damaged or warped discs. MP3/WMA There is no sound even if the PLAY button (y) is pressed. e Check the file format. Non-playable file formats (e.g MPEG 1 LAYER 2 file) cannot be played. "No song title No artist No album' appears on the display. e There is no ID3 tag information for the music file. Edit the song title, artist, and album information of the song on a PC using the MP3 or WMA making application. Some unknown characters are displayed on the display panel. e This unit cannot display symbols and full-size or double-byte characters (such as Japanese, Chinese, etc.) correctly. File name of MP3 or WMA should be alphanumeric characters. iPod Player Cannot insert the iPod. e Check the dock adapter. eRemove dust or obstacles from the Dock connector of the CR-H227i and the iPod, and insert the iPod again. Will not play. e Remove the iPod from the dock, wait a few seconds, and insert it again. e Software update may solve the problem. Visit the Apple website and download the latest iPod Software. Tuner Cannot listen to any station, or signal is too weak. e Tune in the station properly. eRotate the FM or AM antenna for the best reception position. e An external antenna is recommended. Though the broadcast is stereo, it sounds monaural. e Press the FM MODE button. If normal operation cannot be recovered, unplug the power cord from the outlet and plug it again.