ViewSonic PJ1173 PJ1173 User Guide, English - Page 115
Regarding the indicator lamps
UPC - 766907299014
View all ViewSonic PJ1173 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Troubleshooting Regarding the indicator lamps Lighting and flashing of the POWER indicator, the LAMP indicator, and the TEMP indicator have the meanings as described in the table below. Please follow the instructions within the table. If the same indication is displayed after the remedy, or if an indication other than the following is displayed, please contact ViewSonic or service company. POWER LAMP TEMP indicator indicator indicator Description Lighting Turned Turned The projector is in a standby state. In Orange off off Please refer to the section "Power On/Off". Blinking Turned Turned The projector is warming up. In Green off off Please wait. Lighting Turned Turned The projector is in an on state. In Green off off Ordinary operations may be performed. Blinking Turned Turned The projector is cooling down. In Orange off off Please wait. Blinking In Red (discretionary) (discretionary) The projector is cooling down. A certain error has been detected. Please wait until the POWER indicator finishes blinking, and then perform the proper measure using the item descriptions below. Blinking In Red or Lighting In Red Lighting In Red Turned off The lamp does not light, and there is a possibility that interior portion has become heated. Please turn the power off, and allow the projector to cool down at least 20 minutes. After the projector has sufficiently cooled down, please make confirmation of the following items, and then turn the power on again. • Is there blockage of the air passage aperture? • Is the air filter dirty? • Does the peripheral temperature exceed 35°C? If the same indication is displayed after the remedy, please change the lamp referring to the section "Lamp". Blinking In Red or Lighting In Red Blinking In Red Turned off The lamp cover has not been properly fixed. Please turn the power off, and allow the projector to cool down at least 45 minutes. After the projector has sufficiently cooled down, please make confirmation of the attachment state of the lamp cover. After performing any needed maintenance, turn the power on again. If the same indication is displayed after the remedy, please contact ViewSonic or service company. (Continued on next page) ViewSonic 110 PJ1173