Weider 9025 Uk Manual - Page 11

17. Attach the Butterfly Cable (55) to the indicated 17 Cable Pivot (58) with an M8 x 20mm Shoulder Bolt (93) and an M8 Nylon Locknut (73). 93 58 18. Locate the Short Cable (94). Attach the Cable to 18 the Front Upright (4) with an M10 x 72mm Bolt (89), an M10 Washer (71), and an M10 Nylon Locknut (72). 55 73 4 71 72 94 89 19. Wrap the Short Cable (94) under a 90mm Pulley (46). Attach the Pulley and two Pulley Covers (49) to the Double "U"-bracket (51) with an M10 x 53mm Bolt (88) and an M10 Nylon Locknut (72). Make sure the large tabs on the Pulley Covers are on the top. 19 72 Large Tab 49 46 94 51 88 49 20. Attach the Short Cable (94) to the "U"-bracket (53) with an M8 Nylon Locknut (73). Thread the Locknut onto the end of the Cable so that two threads show past the Locknut (see the inset drawing). 21. Locate the High Cable (57). Route the Cable up through the Top Frame (6) and over a 90mm Pulley (46). Attach the Pulley inside the Top Frame with an M10 x 68mm Bolt (87), two M10 Washers (71), two 12mm Spacers (54), and an M10 Nylon Locknut (72). 20 94 94 73 53 73 53 21 57 72 54 6 46 71 71 54 87 11