Weider 9025 Uk Manual - Page 12
Attach the High Cable 57 to the Small U
View all Weider 9025 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
22. Route the High Cable (57) over a 90mm Pulley (46) and down through the Top Frame (6). Attach the Pulley inside the Top Frame with an M10 x 68mm Bolt (87), two M10 Washers (71), two 12mm Spacers (54), and an M10 Nylon Locknut (72). 22 72 54 71 57 46 6 54 71 87 23. Route the High Cable (57) under a 90mm Pulley 23 (46). Attach the Pulley and two Pulley Covers (49) to the upper set of holes in the two Pulley Plates (50) with an M10 x 53mm Bolt (88) and an M10 Nylon Locknut (72). Make sure the large tabs on the Pulley Covers are on the bottom. 24. Route the High Cable (57) over a 90mm Pulley 24 (46). Attach the Pulley inside the Top Frame (6) with an M10 x 68mm Bolt (87), two M10 Washers (71), two 12mm Spacers (54), and an M10 Nylon Locknut (72). 49 57 72 46 49 50 88 Large Tab 50 72 71 54 6 54 71 46 57 87 25. Attach the High Cable (57) to the Small "U"- 25 bracket (52) with an M8 Nylon Locknut (73). Thread the Locknut onto the end of the Cable 57 so that two threads show past the Locknut (see the inset drawing). 96 Attach the Small "U"-bracket (52) to the Weight Tube (18) with an M8 x 45mm Bolt (96) and an M8 Nylon Locknut (73). Do not overtighten the Locknut; the Weight Tube must be able to pivot freely. 52 57 73 73 18 73 52 12