Weider 9025 Uk Manual - Page 9

9. Attach a Cable Pivot (58) to the Right Fly Arm (9) 9 with an M10 x 50mm Bolt (85) and an M10 Nylon Locknut (72). Do not overtighten the Locknut; the Lubricate 86 Cable Pivot must be able to pivot easily. Press a 40mm x 50mm Inner Cap (23) into the Right Fly Arm (9). 85 Lubricate 59 71 58 60 9 Lubricate an M10 x 83mm Button Head Bolt (86) and the flat sides of two Plastic Washers (59) with 59 grease. Attach the Right Fly Arm (9) to the indi- cated side of the Butterfly Frame (11) with the Bolt, two M10 Washers (71), two Butterfly Caps (60), the two Plastic Washers, and an M10 Nylon Locknut (72). Do not overtighten the Locknut; 72 23 Lubricate 60 10 71 11 the Fly Arm must be able to pivot easily. 72 Assemble the Left Fly Arm (10) in the same manner. 10. Wet the lower end of the Right Fly Arm (9) with soapy water. Slide a Large Foam Pad (65) onto the Fly Arm. Attach an Arm Handle (24) to the Right Fly Arm (9) with two M8 x 20mm Button Head Bolts (84). Press a 25mm Dome Inner Cap (25) into the Right Fly Arm (9). Slide a Long Handgrip (102) onto the Fly Arm. Slide the Large Foam Pad (65) down so that it is aligned with the bottom of the Right Fly Arm (9). Repeat this step with the Left Fly Arm (not shown). 11. Press two 38mm Square Inner Caps (29) into the Right and Left VKR Arms (12, 13). Attach the Right and Left VKR Arms (12, 13) to the Rear Upright (3) with two M10 x 72mm Bolts (89) and two M10 Nylon Locknuts (72). 10 9 65 84 84 102 25 24 11 29 13 29 12 89 89 72 3 9