Weider 9025 Uk Manual - Page 5

ASSEMBLY Make Things Easier for Yourself Everything in this manual is designed to ensure that the weight system can be assembled successfully by anyone. However, it is important to realise that the versatile weight system has many parts and that the assembly process will take time. Most people find that by setting aside plenty of time, assembly will go smoothly. Before beginning assembly, carefully read the following information and instructions: • Assembly requires two people. • To make assembly as easy as possible, we have divided the assembly process into four stages. The parts needed for each stage are found in individual bags. Important: Wait until you begin each stage to open the parts bag for that stage. Place all parts of the weight system in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. • Tighten all parts as you assemble them, unless instructed to do otherwise. • As you assemble the weight system, make sure all parts are oriented as shown in the drawings. • For help identifying small parts, use the PART IDENTIFICATION CHART. The following tools (not included) are required for assembly: • two adjustable spanners • one rubber mallet • one standard screwdriver • one Phillips screwdriver • lubricant, such as grease or petroleum jelly, and soapy water. Assembly will be more convenient if you have a socket set, a set of open-end or closed-end spanners, or a set of ratchet spanners. Frame Assembly 1 1. Before you begin, make sure that you have carefully read the instructions at the top of this page. Attach a Base Cap (32) to the Stabiliser (2) with two M4 Washers (75) and two M4 x 16mm Selftapping Screws (74). Attach another Base Cap to the Stabiliser in the same manner. Insert two M8 x 67mm Carriage Bolts (82) and an M10 x 67mm Carriage Bolt (107) up through the Stabiliser (2). It may be helpful to place a piece of tape over the bolt head to hold it in place. 32 107 82 2 32 75 74 5