Weider 9025 Uk Manual - Page 17
Warning
View all Weider 9025 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
CONVERTING THE BUTTERFLY ARMS To use the Fly Arms (9, 10) as butterfly arms, insert the "L"-pins (100) into the butterfly holes in the Front Upright (4) and the tab on the back of the Butterfly Frame (11). To use the Fly Arms (9, 10) as press arms, insert the "L"-pins (100) into the press holes in the Butterfly Frame (11). Make sure that the "L"-pins (100) are fully inserted into the same set of holes before performing any exercises. 100 Butterfly Press 11 100 4 ATTACHING THE SEAT Set the Seat Frame (7) on the pin on the Front Upright (4). Secure the Seat Frame with an M8 x 67mm Carriage Bolt (82) and the M8 Knob (106). For some exercises, the Seat (7) must be removed. First, make sure that the chain is not attached to the leg lever (see ATTACHING THE LEG LEVER, below). Next, remove the M8 Knob (106) and M8 x 67mm Carriage Bolt (82) from the Seat Frame. Lift the Seat Frame off the Front Upright (4). ATTACHING THE LEG LEVER To use the Leg Lever (8), first attach the seat to the weight system (see ATTACHING THE SEAT, above). Next attach the Low Cable (56) to the M10 x 63mm Eyebolt (97) with the Chain (99) and two Cable Clips (68). CHANGING THE STEPPING RESISTANCE To change the stepping resistance, lift the Right and Left Pedals (14, 15) off the hooks at the lower ends of the Resistance Cylinders (37). Move the hooks to different slots under the Pedals. Make sure that the hooks are fully inserted into the slots in the same position under both Pedals. The farther the hooks are moved from the Rear Upright (3), the greater the resistance will be. WARNING: The Resistance Cylinders (37) become very hot during use. Allow the Resistance Cylinders to cool before touching them. 17 106 4 7 82 Pin 8 97 68 99 56 68 37 14 15