Weider 9025 Uk Manual - Page 13
mm Spacers 45, and an M10 Nylon Locknut
View all Weider 9025 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
26. Locate the Low Cable (56). Route the Cable through the Front Upright (4) and under a 90mm Pulley (46). Attach the Pulley and two Pulley Covers (49) inside the Upright with an M10 x 68mm Bolt (87), two M10 Washers (71), two 10mm Spacers (45), and an M10 Nylon Locknut (72). Make sure the large tabs on the Pulley Covers are in the indicated position. 26 Large Tab 49 45 72 71 4 56 46 49 45 87 71 27. Route the Low Cable (56) over a 90mm Pulley 27 (46). Attach the Pulley and two Pulley Covers (49) to the bottom set of holes in the "U"-bracket (53) with an M10 x 53mm Bolt (88) and an M10 Nylon Locknut (72). Make sure the large tabs on the Pulley Covers are on the top. 53 72 Large Tab 49 46 56 88 49 28. Wrap the Low Cable (56) under a 90mm Pulley (46). Attach the Pulley and two Pulley Covers (49) to the Base (1) with an M10 x 53mm Bolt (88) and an M10 Nylon Locknut (72). Make sure the 28 Small Tab small tabs on the Pulley Covers are on the top. 49 72 56 46 29. Route the Low Cable (56) over a 90mm Pulley (46). Attach the Pulley and two Pulley Covers (49) to the first set of holes from the bottom of the Pulley Plates (50) with an M10 x 53mm Bolt (88) and an M10 Nylon Locknut (72). Make sure the large tabs on the Pulley Covers are on the top. 29 Large Tab 49 30. Attach the Low Cable (56) inside the Base (1) with an M10 x 68mm Bolt (87), two M10 Washers (71), and an M10 Nylon Locknut (72). 30 72 71 1 88 49 72 50 88 46 56 49 56 71 1 87 13