Weider 9250 Uk Manual - Page 11
Cable Assembly
View all Weider 9250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
15. Lubricate the axles on the Top Frame (55). Orient 15 the Right Butterfly Arm (48) as shown and slide it onto the right axle. Make sure the Butterfly Arm is behind the bracket on the Top Frame. Have a second person secure the Right Butterfly Arm (48) to the axle with two 25mm Retainers (68) and a 25mm Cover Cap (65). Note: Place the Retainers on top of the inverted Cover Cap, as shown in the inset drawing; make sure the teeth on the Retainers bend toward the Cover Cap. Gently tap the Cover Cap onto the axle. Repeat this step with the Left Butterfly Arm (47). Cable Assembly 16 16. For cable identification and routing during steps 16 to 44, refer to the CABLE DIAGRAMS on page 25. Do not overtighten the locknuts securing the pulley; the pulleys must be able to roll easily. Locate the High Cable (11), which has a ball on one end and an eyelet on the other. Route the eyelet end of the Cable up through the Top Frame (55) and around a "V"-Pulley (6). Attach the Pulley inside the Top Frame with an M10 x 75mm Bolt (76), two 12.5mm Spacers (82), two M10 Washers (9), and an M10 Nylon Locknut (21). 17 17. Wrap the High Cable (11) around a "V"-Pulley (6). Attach the Pulley and a Long Cable Trap (50) to the bracket on the Top Frame (55) with an M10 x 60mm Bolt (7) and an M10 Nylon Locknut (21). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 55 Bracket 47 Lubricate Axle 48 68 65 Axle 68 65 11 6 76 55 82 9 82 21 9 50 6 7 11 55 21 11