Weider 9250 Uk Manual - Page 16

33. Wrap the Low Cable (69) under a 90mm Pulley 33 (15). Attach the Pulley and a pair of Pulley Covers (40) to the upper hole in the Front Upright (42) with an M10 x 115mm Bolt (102), an M10 Thick Spacer (104), an M10 Washer (9), and an M10 Nylon Locknut (21). Make sure the large tabs on the Pulley Covers are on the side shown. 40 104 15 69 9 102 Large Tab 21 40 42 34. Wrap the Low Cable (69) around a 90mm Pulley 34 (15). Attach the Pulley and a pair of Pulley Covers (40) to the Press Frame (17) with an M10 x 135mm Bolt (75) and an M10 Thick Spacer (104). Make sure the small tabs on the Pulley Covers are on the side shown. Note: A nylon locknut will be attached to the bolt in step 36. 69 17 Small Tab 104 40 15 40 75 35. Wrap the Low Cable (69) around a "V"-Pulley (6). 35 Attach the Pulley and a Long Cable Trap (50) to the second hole from the end of the tube on the Front Upright (42) with an M10 x 80mm Bolt (8), two M10 Washers (9), and an M10 Nylon Locknut (21). 42 21 69 9 50 6 9 8 36. Wrap the Low Cable (69) around a 90mm Pulley 36 (15). Attach the Pulley and a pair of Pulley Covers (40) to the Press Frame (17) with the M10 x 135mm Bolt (75) used in step 34 and an M10 Nylon Locknut (21). Make sure the small tabs on the Pulley Covers are on the side shown. 16 Small Tab 69 21 40 15 40 75 17