Weider 9250 Uk Manual - Page 13

22. Locate the Weight Cable (23), which has a bolt 22 on each end. Attach the Cable to the Large "U"- Bracket (90) with an M8 Washer (70) and an M8 Nylon Locknut (3). Do not completely tighten the Nylon Locknut; it should be threaded only two turns onto the end of the Cable, as shown in the inset drawing. 23. Wrap the Weight Cable (23) under a 90mm Pulley 23 (15). Attach the Pulley and a pair of Pulley Covers (40) to the Pulley Plates (58) with an M10 x 52mm Bolt (12) and an M10 Nylon Locknut (21). Make sure the small tabs on the Pulley Covers are on top. 24. Route the Weight Cable (23) up through the Top 24 Frame (55). Wrap the Cable around a 90mm Pulley (15). Attach the Pulley inside the Top Frame with an M10 x 75mm Bolt (76), two 17.5mm Spacers (77), two M10 Washers (9), and an M10 Nylon Locknut (21). 3 70 90 23 90 3 11 23 21 Small Tabs 58 40 15 40 58 12 55 15 77 23 77 76 9 21 9 25. Wrap the Weight Cable (23) around a 90mm 25 Pulley (15) and route it down through the Top Frame (55). Attach the Pulley inside the Top Frame with an M10 x 80mm Bolt (8), two 17.5mm Spacers (77), two M10 Washers (9), and an M10 Nylon Locknut (21). 23 15 8 77 55 77 9 21 9 13