Weider 9250 Uk Manual - Page 22

ATTACHING THE SEAT FRAME To attach the Seat Frame (36) to the Front Upright (42), slide one of the three slots in the bracket on the Seat Frame onto the pin on the Upright. Note: The Seat Frame can be adjusted to three different heights using the three slots. Secure the Seat Frame to the Upright with the M10 x 80mm Carriage Bolt (99) and the Seat Knob (49). For some exercises, the Seat Frame (36) must be removed. First, make sure that the chain is not attached to the leg lever. Next, remove the Seat Knob (49) and the M10 x 80mm Carriage Bolt (99) from the Seat Frame. Lift the Seat Frame off the Front Upright (42). Slot 49 99 Pin 36 42 ATTACHING THE LEG LEVER TO THE LOW CABLE To use the Leg Lever (29), the seat frame must be attached to the front upright (see ATTACHING THE SEAT FRAME above). Attach one end of the Chain (52) to the end of the Low Cable (69) by the Front Upright (42) with a Cable Clip (53). Attach the other end of the Chain to the bracket on the back of the Leg Lever (29) with another Cable Clip. ATTACHING THE CURL PAD To attach the Curl Pad (24) to the weight system, the seat frame must be attached to the front upright (see ATTACHING THE SEAT FRAME above). Remove the 38mm Square Inner Cap (32) from the Seat Frame (36). Insert the Curl Post (35) into the Seat Frame and secure it with the Curl Knob (51). Always remove the Curl Pad (24) when it is not in use, and replace the 38mm Square Inner Cap (32). 42 69 29 53 52 51 32 35 24 36 22