Weider Pro 2000 Uk Manual - Page 17
Adjustments - exercise chart
View all Weider Pro 2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
ADJUSTMENTS This section explains how to adjust the weight system. Refer to the accompanying exercise guide to see the correct form for each exercise. Make sure all parts are properly tightened each time you use the weight system. Replace any worn parts immediately. The weight system can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents. ATTACHING THE LAT BAR Attach the Lat Bar (31) to the High Cable (50) with a Cable Clip (33). Note: The Lat Bar can be attached to the Low Cable (not shown). Remove the Lat Bar when performing exercises that do not require it. USING THE Butterfly Arms 50 6 33 39 To do press arm exercises, push the Press Frame Lock (39) to the position shown to lock the Right and Left Arms (6, 7). To do fly exercises, lift the Press Frame Lock until the Press Arms are free. 31 7 CHANGING THE WEIGHT SETTING To change the weight setting, insert a Weight Pin (16) under the desired Weight (15) until the bent end of the Weight Pin touches the Weights. Turn the bent end downward. Note: Due to the cables and pulleys, the amount of resistance at each exercise station may vary from the weight setting. Use the WEIGHT RESISTANCE CHART on page 18 to find the approximate amount of resistance at each weight station. 16 15 REMOVING THE SEAT Disconnect the Low Cable (48) from the Chain (83). Remove the M8 Knob (82) and the M8 x 70mm Carriage Bolt (86). Lift the Seat Frame (8) off the pin on the Upright (3). 3 86 Pin 8 83 48 17