Xerox 5550N User Guide (English) - Page 33
Choosing a Connection Method, Connecting via Ethernet (Recommended)
UPC - 095205737257
View all Xerox 5550N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Choosing a Connection Method Choosing a Connection Method Connect the printer via Ethernet, USB, or parallel. A USB or a parallel connection is a direct connection and is not used for networking. An Ethernet connection is used for networking. Hardware and cabling requirements vary for the different connection methods. Cabling and hardware are generally not included with your printer and must be purchased separately. This section includes: ■ Connecting via Ethernet (Recommended) on page 3-3 ■ Connecting via USB on page 3-4 ■ Connecting via Parallel on page 3-4 Connecting via Ethernet (Recommended) Ethernet can be used for one or more computers. It supports many printers and systems on an Ethernet network. An Ethernet connection is recommended because it is faster than a USB connection. It also allows you direct access to CentreWare Internet Services (IS). The CentreWare IS web interface enables you to manage, configure, and monitor networked printers from your desktop. Network Connection Depending on your particular setup, the following hardware and cabling is required for Ethernet. ■ If you are connecting to one computer, an Ethernet RJ-45 crossover cable is required. ■ If you are connecting to one or more computers with an Ethernet hub, or cable or DSL router, two or more twisted-pair (category 5/RJ-45) cables are required. (One cable for each device.) If you are connecting to one or more computers with a hub, connect the computer to the hub with one cable, and then connect the printer to the hub with the second cable. Connect to any port on the hub except the uplink port. See also: Configuring the Network Address on page 3-5 Available Printer Drivers on page 3-12 Phaser® 5550 Printer 3-3