Yamaha DTX500 Owner's Manual - Page 31

7 Create Your Own Original Drum Kit 20 Change the Reverb Type This determines the Type of Reverb effect for each Drum Kit. The same Reverb Type is applied to the entire Drum Kit. * This setting affects the entire Drum Voice. The ˙/¶ indication is not shown in the upper right corner of the display. Use the [>] button to call up the KIT20 page, then rotate the jog dial to set the Reverb Type. KIT20* "RevType=hall1~, none No reverb (same as thru). hall1-5 ....... Simulates the reverb in a hall. room1-5 ....... Simulates the reverb in a room. stage1-5 ..... Simulates the ambience of a stage. plate Simulates a steel plate reverb. white A special short reverb effect. tunnel ......... Simulates the reverb of a tunnel. bsemnt ......... Simulates the reverb of a basement. * The hall, room, or stage types with larger values produce a more pronounced reverb effect. 21 Change the Reverb Level (3) This determines the Signal Return Level from the reverb effect for every Drum Kit. The same reverb type is applied to the entire Drum Kit. By setting the level, you can adjust the reverb effect for the overall DTX500 system. * This setting affects the entire Drum Voice. The ˙/¶ indication is not shown in the upper right corner of the display. Use the [>] button to call up the KIT21 page, then rotate the jog dial to set the Reverb Master Return level (0-127). KIT21* "RevMastRet=~64, 22 Set the Pad Controller This is effective only when a pad equipped with pad controller is connected to the 1SNARE jack, and also when "SN1", "SN-2", "TM-1" or "TM-2" is assigned in the TRG2 page (pad type) of the Trigger Setup pages. The following settings can be made by rotating the pad controller knob. off No function is assigned. snares ..........Adjusting the snares (also effective for the open rim sound) tuning ..........Adjusting the tuning (also effective for the open rim sound) tempo Adjusting the tempo * The ˙/¶ indication is not shown in the upper right corner of the display. Use the [>] button to call up the page KIT22, then rotate the jog dial to set the Pad Controller function. KIT22* "PadCtl=snares~, 23 Set the Snares This adjusts the snares effect (the characteristic sound of the coiled wires on the bottom of an actual snare drum) of the pad connected to the 1SNARE jack. This also applies to pads not having a pad controller. * The ˙/¶ indication is not shown in the upper right corner of the display. Use the [>] button to call up the KIT23 page, then rotate the jog dial to set the Snares adjustment level. KIT23* "~~Snares=24~~~, off Snares off (reproduces the sound with the snares lifted off the drum) 1-24 Snares are applied to the sound; the higher the value, the tighter the snares sound. (A value of "1" is the "loosest" snares setting.) * When you change this setting, the decay setting (KIT6) for the input sources "ƒsnare" and "ƒsnrOp" also changes. 31 DTX500 Owner's Manual