Yamaha DTXPLORER Owner's Manual - Page 10
Connecting to Speakers or Headphones, OUTPUT L/MONO, R Jack Monaural Standard Phone - setup
View all Yamaha DTXPLORER manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Connections ● Some Advice On Connections • Trigger Input jacks 5 RIDE and 6 CRASH are stereo input type jacks. These jacks can be connected to switch equipped pads such as the TP65S, PCY65S, PCY130S, etc. • 3-Zone pads like the TP65S, PCY150S, etc., can be connected to Trigger Input jack 1 SNARE. • Pad sensitivity is set in the Trigger Setup Edit's [TRIG2 Type (Pad type)] setting (P. 25). • Using the supplied stereo cable to connect the KP65 kick pad to the main unit allows the connection of an additional pad to Input jack 9 via the external pad input jack on the KP65. ■ Connecting to Speakers or Headphones The DTXPLORER is not equipped with built-in speakers. The unit must be connected to an external amp + speaker system or headphones for sound output. Monitor system for the DTX series MS100DRJ, MS50DRJ, etc. Headphones OUTPUT L/MONO and R jacks PHONES jack CAUTION Whenever making connections, make sure that the cable being used is equipped with a plug that corresponds to the jack type on the specific device. ● OUTPUT L/MONO, R Jack (Monaural Standard Phone Jack) With these jacks you can connect the DTXPLORER to a mixer or audio equipment to produce sound from external speakers, or connect the DTXPLORER to audio recording equipment for recording your own performance. * Use the DTXPLORER's OUTPUT L/MONO jack when connecting to a device with a monaural input. ● PHONES Jack (Standard Stereo Phone Jack) Use the VOLUME knob on the rear panel to adjust headphone volume. Whenever using headphones, take care not to damage your hearing. Use the equipment with the volume adjusted to a comfortable level. 10