Yamaha DTXPLORER Owner's Manual - Page 27

TRIG7 SPRej (Specified Rejection Level) TRIG7 ¡snare 0% -SPRej=0from= 1, SPRej from [Range] 0 to 9 [Range] 1 to 9, 56 This setting is used to prevent cross talk between the input jack assigned in the upper half of the display and the input jack assigned in the "from=" setting. After an event occurs from the pad that is assigned in the "from=" setting, the pad assigned in the upper half of the display will not sound for a certain length of time unless the input level is greater than the value set here. Larger values will require a greater input level in order to produce a trigger event. A "from=56" setting assigns both trigger inputs 5 and 6. Trigger Setup Edit 3. Press the [SAVE/ENT] button to carry out the copy operation. * To cancel the copy operation, press any button except for the [SAVE/ENT] and [SHIFT] buttons (the jog dial will also cancel the operation). The following display appears after the copy operation is complete. Completed! TRIG8 Copy to Input (Trigger Setup Copy) TRIG8 ¡snare -Copy to Input=2 This function copies all data settings in pages [TRIG2 Type (Pad Type)] through [TRIG7 SPRej (Specified Rejection Level)] to another input jack. CAUTION When the Trigger Setup Copy operation is carried out, the trigger setup data will be replaced with the settings of the copy source. Procedure 1. Hit a pad to select the copy source (trigger input) from which the data will be copied. Rotate the jog dial and assign the copy destination (trigger input) to which the data will be copied. Trigger Input (jack) to be copied TRIG8 ¡snare -Copy to Input=2 Destination Trigger Input to which the data will be copied to 2. Press the [SAVE/ENT] button. The following display asking your confirmation to proceed with the copy operation. Input Copy to 2 Are you sure ? 27