Yamaha DTXPLORER Owner's Manual - Page 8

Nomenclature Rear Panel !1 !2 !5 !6 !7 !8 MIDI OUT 1 SNARE 2TOM1 3TOM2 4TOM3 MIN MAX R L/MONO PHONES AUX IN VOLUME 5 RIDE 6 CRASH 7HIHAT 8 KICK/9 HI HAT CONTROL DC IN 12V ON STANDBY !2 !3 !4 !9 @0 @1 !1 MIDI OUT Jack This jack is used to send data from the DTXPLORER to an external MIDI device. With this jack, you can use the DTXPLORER as a control device to trigger voices from an external tone generator, or synchronize the DTXPLORER's song or metronome playback with the playback of an external sequencer. (P. 11) !2 Trigger Input Jacks (1 SNARE thru 7 HI HAT) These jacks are used to connect the pads or trigger sensors to the main unit. Connect pads such as snare, tom, etc., according to the indication below each input. (P. 9) 3-zone jack 1 SNARE jack Stereo (w/switch) jacks 5 RIDE, 6 CRASH jacks Monaural jacks 2 TOM1, 3 TOM2, 4 TOM3, 7 HI HAT jacks !3 Trigger Input jack (8 KICK/9) This jack is used to connect the kick pad to the main unit. Using the supplied stereo cable to connect the KP65 kick pad to the main unit allows the connection of an additional pad to Input jack 9 via the external pad input jack on the KP65. !4 Hi-Hat Controller Jack (HI HAT CONTROL) This jack is used to connect a hi-hat controller. (P. 9) * Use a cable with a stereo plug (shown below) when connecting a Hi-hat controller. Double Insulator !6 Head Phone Jack (PHONES) Connect a pair of headphones to this jack to monitor the DTXPLORER. (P. 10) !7 AUX IN Jack Connect the output of an external audio device, etc., to this jack (stereo mini jack). (P. 10) This is convenient for playing along with music from a CD or cassette player. * Use the volume control on the external device (CD, cassette player, etc.) to adjust the volume balance. !8 Master Volume (VOLUME) Adjusts the DTXPLORER's overall volume (output level of the signal delivered by the OUTPUT jacks and PHONE jack). Rotate the knob clockwise to increase volume, and counter-clockwise to decrease. !9 Power Supply Jack (DC IN 12V) Connect an AC adaptor to this jack. To prevent the adaptor from becoming unplugged, secure the cord to the cord hook @0. @0 Cord Hook Prevents the power cord from accidentally becoming unplugged. (P. 11) @1 Power Switch (POWER) This is the DTXPLORER's power switch. !5 Output Jacks (OUTPUT L/MONO, R) These jacks are used to connect the DTXPLORER to an external amplifier, mixer, etc. For monaural playback use the L/MONO jack. For stereo playback connect both L/R jacks. 8