Yamaha DTXPLORER Owner's Manual - Page 16
Click Out Select - output
View all Yamaha DTXPLORER manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Play Along With The Metronome 8. Save an Original Click Set After creating your own original click set, save it in the DTXPLORER's memory using the Store Operation described below. * Any changes made to the data will be lost if another click set is selected before carrying out the store operation. 8-1. Press the [SAVE/ENT] button. The following display will appear. CLK save to 1 8-2. Rotate the jog dial to select the destination memory number (1 to 30) that you want to store the click set in. 8-3. Press the [SAVE/ENT] button again and the following display asking your confirmation to proceed with the store operation. CLK save to 1 Are you sure ? Store Destination 8-4. Press the [SAVE/ENT] button to carry out the store operation. * To cancel the store operation, press any button except for the [SAVE/ENT] and [SHIFT] buttons (when "Are you sure?" appears in the display, the jog dial will also cancel the operation). The following display appears after the store operation is complete. Completed! You can use the "Factory Set" operation to reset the contents of click sets 1 through 30 to their original factory condition. However, please proceed with caution because carrying out this operation will rewrite the DTXPLORER's entire contents (all click sets, user trigger setup (No. 5), user drum kits 33 to 42) with the data that was set in the unit's memory when it was shipped from the factory. (P. 23) Click Out Select The DTXPLORER lets you select from which output jack the metronome's signal is delivered. Click output and performance output can be routed to separate outputs. Procedure 1. Press the [SHIFT] + [SAVE/ENT] buttons and the following display will appear. (Page 1 in the Utility Mode.) UTIL1 Hi-hat HHofs= 0 T= 0, 2. Next, press the [>] button twice so that the following display appears. UTIL2 Click -OutSel=mix , 3. Rotate the jog dial to select the output from the outputs listed below. mix: This is the standard output setting. The click signal is delivered from both the OUTPUT L and R jacks. clickL: The click signal is delivered from the OUTPUT L jack only. All drum performance and song playback is delivered in monaural via the OUTPUT R jack. clickR: The click signal is delivered from the OUTPUT R jack only. All drum performance and song playback is delivered in monaural via the OUTPUT L jack. * The PHONES jack delivers the same signal as the OUTPUT jacks. The settings in this section would then be applied to the PHONES jack's stereo L and R. 16