Yamaha HTR 5790 MCXSP10 Manual - Page 44

RECORDING RECORDING Recording adjustments and other operations are performed from the recording components. Refer to the operation instructions for those components. STANDBY /ON OPTIMIZER MIC PHONES SPEAKERS A B SILENT CINEMA VOLUME PRESET/TUNING EDIT STRAIGHT FM/AM A/B/C/D/E PRESET/TUNING PROGRAM TONE CONTROL INPUT MODE EFFECT MEMORY MAN'L/AUTO FM INPUT TUNING MODE AUTO/MAN'L MONO MULTI CH INPUT VIDEO AUX S VIDEO VIDEO L AUDIO R OPTICAL (U.S.A. model) 1 2 1 Turn on the power of this unit and all connected components. 2 Select the source component you want to record from. INPUT or PHONO TUNER CD MULTI CH IN V-AUX CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR2 DVD Front panel Remote control 3 Start playback (or select a broadcast station) on the source component. 4 Start recording on the recording component. Notes • Do a test recording before you start an actual recording. • When this unit is set in the standby mode, you cannot record between other components connected to this unit. • The setting of TONE CONTROL, VOLUME, "Speaker level" (page 50) and programs does not affect the recorded material. • A source connected to the MULTI CH INPUT jacks of this unit cannot be recorded. • S-video and composite video signals pass independently through this unit's video circuits. Therefore, when recording or dubbing video signals, if your video source component is connected to provide only an S-video (or only a composite video) signal, you can record only an S-video (or only a composite video) signal to your VCR. • A given input source is not output on the same REC OUT channel. (For example, the signal input from VCR 1 IN is not output on VCR 1 OUT.) • Check the copyright laws in your country to record from records, CDs, radio, etc. Recording of copyrighted material may infringe copyright laws. If you playback a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture itself may be disturbed due to those signals. ■ Special considerations when recording DTS software The DTS signal is a digital bitstream. Attempting to digitally record the DTS bitstream will result in noise being recorded. Therefore, if you want to use this unit to record sources that have DTS signals recorded on them, the following considerations and adjustments need to be made. For LDs, DVDs and CDs encoded with DTS, when your player is compatible with the DTS format, follow its operation instruction to make a setting so that the analog signal will be output from the player. 40