Yamaha HTR 5790 MCXSP10 Manual - Page 64

REMOTE CONTROL FEATURES Setting manufacturer codes You can control other components by setting the appropriate manufacturer codes. Codes can be set up for each input area. The following table shows the factory preset component (Library: component category) and the manufacturer code for each area. Input area PHONO TUNER CD V-AUX CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR2 DVD Component category (Library) TV TUNER CD VCR CABLE MD CD-R TV VCR VCR DVD Manufacturer - YAMAHA-1 YAMAHA-1 - - YAMAHA-1 YAMAHA - - - YAMAHA-1 Note You may not be able to operate your YAMAHA component even if a YAMAHA manufacturer code is initially set as listed above. In this case, try to set other YAMAHA manufacturer code(s). 1 Press an input selector button to select the source component you want to set up. PHONO TUNER CD MULTI CH IN V-AUX CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR2 DVD 2 Press and hold LEARN for about 3 seconds using a ballpoint pen or similar object. "SETUP" and the selected component name appear alternately in the display window. LEARN If you want to change a library (component category), press j / i. You can set a different type of component. Library choices: L:DVD, L:LD, L:CD, L:CDR, L:MD, L:TAP (tape), L:TUN, L:AMP*, L:TV, L:CAB (cable), L:DBS, L:SAT, L:VCR * The amplifier Library (L:AMP) code is preset to "YPC" to operate this unit. However, you can switch between the following two codes if necessary. • The initial setting for "Amplifier library" is "YPC". YPC To operate this unit. ZONE (U.S.A., Canada and Australia models only) To operate ZONE 2 or ZONE 3 features. 3 Press u / d to select the name of your component's manufacturer. You will find the names of most worldwide audiovideo manufacturers in alphabetical order in the display window. + TV VOL CH - PRESET TV MUTE SELECT TV VOL - CH + PRESET 4 Press one of the buttons shaded below to see if you can control your component. If you can, the manufacturer code is correct. POWER TV REC DISC SKIP POWER AV AMP AUDIO + VOL - LEVEL TITLE TV INPUT + TV VOL SET MENU MENU A/B/C/D/E MUTE y • If the manufacturer of your component has more than one codes, try each of them until you find the correct one. • If you continuously want to set up another code for another component, press TV MUTE/SELECT and repeat steps 1, 3 and 4. Be sure to press and hold LEARN for at least 3 seconds, otherwise the learning process will start. y Complete each of the following steps in 30 seconds. Otherwise, the learning mode will be automatically canceled. In this case, press LEARN again. 60