Yamaha HTR 5790 MCXSP10 Manual - Page 66
Changing source names in the display window, Press RE-NAME using
UPC - 027108919744
View all Yamaha HTR 5790 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
REMOTE CONTROL FEATURES POWER AV POWER TV DTV V-AUX CBL/SAT MD/TAPE CD PHONO TUNER STANDBY SYSTEM POWER TRANSMIT 5 Press and hold the button you want to program on the other remote control until "OK" appears in the display window. Changing source names in the display window You can change the name that appears in the display window on the remote control if you want to use the different name than the factory preset. This is useful when you have set the input selector to control a different component. RE-NAME CLEAR LEARN SLEEP INPUT MODE VCR 1 DVR/VCR2 DVD MULTI CH IN CD-R SELECT AMP Notes • "NG" appears in the display window if programming was unsuccessful. In this case, start over from step 5. • This remote control can learn approximately 120 functions. However depending on the signals learned, "FULL" may appear in the display before you program 120 functions. In this case, clear unnecessary programmed functions to make room for further learning. 6 Repeat steps 4 and 5 to program additional functions. 7 Press LEARN again to exit from the learning mode. LEARN Notes • Learning may not be possible in the following cases: - When the batteries in the remote control for this unit or other components are weak. - When the distance between the two remote controls is too great or too small. - When the remote control infrared windows are not facing at the appropriate angle. - When the remote control is exposed to direct sunlight. - When the function to be programmed is continuous or uncommon. • "ERROR" appears in the display window if you press more than one button at the same time. 1 Press an input selector button to select the source component you want to rename. The selected component name appears in the display window. PHONO TUNER CD MULTI CH IN V-AUX CBL/SAT MD/TAPE CD-R DTV VCR 1 DVR/VCR2 DVD 2 Press RE-NAME using a ballpoint pen or similar RE-NAME object. 3 Press u / d to select and enter a character. Pressing d changes the character as follows: A to Z, a to z, 0 to 9, space, -(hyphen), and /(slash). (Pressing u changes the characters in reverse order.) + TV VOL CH - PRESET TV MUTE SELECT TV VOL - CH + PRESET 4 Press j / i to move the cursor to the next position. + TV VOL CH - PRESET TV MUTE SELECT TV VOL - CH + PRESET y If you want to continue setting up names for other components, press TV MUTE/SELECT and repeat steps 1, 3 and 4. 5 Press RE-NAME again to exit from the renaming mode. RE-NAME 62